Menu
Your Cart

FedExUPS, and DHL have suspended all operations in Ukraine, Belarus, and Russia, including inbound and outbound operations.

RHP Boson Tau Replicator Board

RHP Boson Tau Replicator Board
RHP Boson Tau Replicator Board
RHP Boson Tau Replicator Board
RHP Boson Tau Replicator Board
RHP Boson Tau Replicator Board
Highlights:
  • 5 to 26Volts DC Input
  • Reverse Polarity Protected
  • Low Profile
  • Connects to TAU 2 VPC or Camera Link Modules

$0.00
  • : Request a Quote
  • SKU: rhp-bos-tau-rp-if

When attaching this Interface, please use proper personal grounding (or grounding wrist strap) to prevent static damage to the module.

RHP-BOS-TAU-RB-IF

Boson Tau Replicator Interface

The replicator board adapts the Tau 2 interfaces electronically to make them compatible to the FLIR Boson Camera. By adapting the Boson's native 80-pin Hirose connector to the 50-pin TAU 2 connector used on FLIR's Tau 2 camera accessories, it makes the FLIR Boson camera electrically pin-compatible to the same connection as the TAU 2 providing an easy way to integrate the Boson to an existing installation.




Easy Integration

By adapting the Boson's native 80-pin Hirose connector to the 50-pin TAU 2 connector used on FLIR's Tau 2 camera accessories, it makes the FLIR Boson camera electrically pin-compatible to the same connection as the TAU 2 providing an easy way to integrate the Boson to an existing installation.



TAU 2 VPC or Camera Link

Using an existing TAU 2 VPC or Camera Link Accessory Module is possible. Plug the Boson Tau 2 replicator accessory directly into the rear of the Boson camera 80-pin connector. Once connected, plug the Tau 2 accessory into the 50-pin connector. When the boards are mated, use the included screws to secure the boards to the camera.

Note: Using longer screws could damage the camera.



Reverse Polarity Protected

With the intelligent polarity sensing protection, the RHP-BOS-TAU-RB-IF can be powered with a 5-26VDC power source


INFORMATION
What's In The Box

Tags: rhp , bos , tau , rp , if

Interface Assemblies Frequently Asked Questions

The FLIR Boson requires at least one interface board to allow Power and acquire Video from it's high-density connector. 

The most popular board in our product list is the Low Profile VPC module. It allows for power input, streaming USB and composite analog video as well as controlling the cameras settings.

A complete list of accessories are available at: https://www.oemcameras.com/boson_accessories.

For video acquisition and control you will need to use the Boson Controller GUI 3.0 available from Teledyne FLIR. 

With  the RHP Boson interface boards, you may also use the RHP Boson GUI

If the USB Sensor in the Teledyne FLIR Boson is not triggered (on startup) with the proper voltage for USB-3, it will default to USB-2.

There are three ways to correct this. 

  1. Disconnect the device from the PC and reconnect.  
  2. When powering from a PC, it is best to connect USB-3 after the computer has booted up. 
  3. In some cases, the RHP-BOS-VPC3-IF can be modified to disable the voltage protection.
    Please contact support before placing your order for this modification.