By clicking on or navigating the site, you agree to allow us to collect information on and off this site through cookies. Learn more.
RHP Boson RC-IF Remote Control Interface
Control the FLIR BOSON remotely with the "RC-IF" Remote Control Interface.
- 6 to 26 Volts DC Input
- Reverse Polarity Protection
- Control w/RC Receiver
- S-Bus & PWM
- Color Palette Selection
- (FFC) Flat Field Correction Shutter Control
- (DDE) Digital Detail Enhancement
- Thermal AGC
- Continuous Digital Zoom
- 2 Composite Video Outputs
- USB Video Output
 |
View all of the FLIR BOSON Interface Assemblies at a glance |
|---|---|
| View the FLIR BOSON Matrix to compare models. |
$399.00
SKU
RHP-BOS-RC-IF
RHP-BOS-RC-IF
RC-IF Remote Control Interface for the FLIR Boson
Control the FLIR BOSON remotely with the "RC-IF" Remote Control Interface.
Two Composite Video Outputs allow connections to separate video devices, with no signal loss.
Integrating the Boson Thermal Camera into your UAS has never been easier.
Control the Boson Camera Remotely
The RHP-BOS-RC-IF allows you to control the Boson camera remotely using a 16 Channel S-Bus Signal or up to 5 PWM Signals from your wireless Joystick Remote Control System.
Assign Parameters
Any available parameter on the Boson can be assigned to knobs, switches or levers on a Joystick Remote Controller or direction pad and adjust camera parameters ‘on-the-fly’.
Reverse Polarity Protected
With the intelligent polarity sensing protection, the RHP-BOS-RC-IF can be powered from the 4-Pin JST to USB or 6-Pin JST with a 5-26VDC power source
16 Channel S-Bus & 5 Channel PWM Remote Control Interface Module
- Control Camera Features Remotely
- Powers RC Wireless Receiver
- Wide Input Voltage Range
- Reverse Polarity Protection
- Dual Video Outputs
- Setup and Calibration Software Included
Click Photo to Enlarge
RHP Interface Assemblies for the FLIR Boson
Click Photo to Enlarge
Click Photo to Enlarge
Click Photo to Enlarge
Click Photo to Enlarge
Click Photo to Enlarge
We found other products you might like!
