When attaching this Interface, please use proper personal grounding (or grounding wrist strap) to prevent static damage to the module.
Integrate the Teledyne FLIR Boson into your UAS.
The RHP-BOS-RC-HD-IF allows you to control the Boson camera remotely using a 16 Channel S-Bus Signal or up to 5 PWM Signals from your wireless Joystick Remote Control System. Now you can assign any available parameter on the Boson to any knob, switch or lever on your Joystick Remote Controller and adjust these camera parameters ‘on-the-fly’.
With the HD Video output, video signal can be transmitted securely through a video transmitter in 720 or 1080p. The analog output allows for a composite video signal simultaneously, enabling you to connect to a recording device.
This module accepts a wide input voltage range of 6 to 26 Volts DC with reverse polarity protection while powering your Remote Control receiver with a regulated 5 Volts DC.
Both HD and Composite Video Outputs are available allowing connection to two separate video devices with no signal loss.
Customize and Save ConfigurationsSave configurations for different applications.
• Control via PC
• 16 Channels (S-Bus)
• 5 Channel PWM.
• 5 Channel D-Pad.
• Customize and Assign parameters.
Video OutputsOutput video signals to Analog and HD simultaneously.
• Composite Output
for use with analog transmitters.
• HD Output
use with the latest digital technology.
• Ideal for digital SD recording devices
Control the Boson RemotelyAssign any available parameter on the Boson for ‘on-the-fly’ control.
• Continuous Digital Zoom
• Color Palette Selection
• (FFC)Flat Field Correction
• (DDE)Digital Detail Enhancement
• Wired or Wireless control
|Connections & Communications|
|Digital Video Output||1080p60 / 720p60|
|MAVLink Interface||3.3 Volt (5 Volt Tolerant) UART/TTL Protocol|
|Remote Control||Yes - PWM (5 channels), S-Bus (16 Channels), MAVLink|
|10 Pin Accessory Port||Power Out (5Volts), PWM, S-Bus, MavLink|
|Micro - HDMI||Digital Video Output|
|Input Voltage||6-26VDC (14-PIN JST SVR Connector)|
|5.0 VDC USB-Micro Connector|
Interface Assemblies Frequently Asked Questions
The FLIR Boson requires at least one interface board to allow Power and acquire Video from it's high-density connector.
The most popular board in our product list is the Low Profile VPC module. It allows for power input, streaming USB and composite analog video as well as controlling the cameras settings.
A complete list of accessories are available at: https://www.oemcameras.com/boson_accessories.
For video acquisition and control you will need to use the Boson Controller GUI 3.0 available from Teledyne FLIR.
With the RHP Boson interface boards, you may also use the RHP Boson GUI.
If the USB Sensor in the Teledyne FLIR Boson is not triggered (on startup) with the proper voltage for USB-3, it will default to USB-2.
There are three ways to correct this.
- Disconnect the device from the PC and reconnect.
- When powering from a PC, it is best to connect USB-3 after the computer has booted up.
- In some cases, the RHP-BOS-VPC3-IF can be modified to disable the voltage protection.
Please contact support before placing your order for this modification.