When attaching this Interface, please use proper personal grounding (or grounding wrist strap) to prevent static damage to the module.
Video Power Communication (VPC) Transistor-Transistor Logic Interface Module
With the intelligent polarity sensing protection, power can be provided via the USB connection or DC Voltage using the provided 6-Pin Video/Power cable or the 7-Pin Pico Blade cable.
3 Video Output Options
Video can be viewed through either the supplied JST to USB/Video cable, JST to Bare End Lead cable or 7-Pin Pico Blade to Bare End Lead cable.
Either video output can be changed to provide Sync Input/Output, via a jumper on the back of the RHP-VPC-TTL Board.
Control is maintained over USB or 3.3V TTL signals. This makes TTL Support available for any project integration.
*Please Note: External Sync is disabled on Boson <9 Hz Cameras.
The use of external sync on these cameras is not supported because pulses cannot be correlated to a specific output frame because of the way the reduced frame rate video is created. If attempted, the camera will reject commands to begin external sync mode.
This kit includes:
- 6-PIN JST to USB/RCA Video cable (1)
- 6-PIN JST to Bare End Leads (1)
- 7-PIN PICO Blade to Bare End Leads (1)
- M1.6 6mm Screws (4)
- M1.6 10mm Screws (4)
- Rear Cover for VPC-TTL Board (1)
- Allen Key (1)
- RHP VPC-TTL-IF Board (1)
- Quick Start Guide (1)
|Power Requirements:||5 Volts DC - 26 Volts DC|
|Power Dissipated:||Avg. 0.84W - Max. 2W|
|Dimensions:||21mm x 21mm|
|Control:||USB 2.0 and/or 3.3V TTL (1.8V Logic Available)|
|Video Output:||NTSC 30Hz / PAL 25Hz|
|Sync Output: (if configured)||Master/Slave|
|What's In The Box||
Click Photo to Enlarge