



- 5 to 26Volts DC Input
- Reverse Polarity Protected
- Low Profile
- Connects to TAU 2 VPC or Camera Link Modules
- SKU: rhp-bos-tau-rp-if
When attaching this Interface, please use proper personal grounding (or grounding wrist strap) to prevent static damage to the module.
Boson Tau Replicator Interface
The replicator board adapts the Tau 2 interfaces electronically to make them compatible to the FLIR Boson Camera. By adapting the Boson's native 80-pin Hirose connector to the 50-pin TAU 2 connector used on FLIR's Tau 2 camera accessories, it makes the FLIR Boson camera electrically pin-compatible to the same connection as the TAU 2 providing an easy way to integrate the Boson to an existing installation.

Easy Integration
By adapting the Boson's native 80-pin Hirose connector to the 50-pin TAU 2 connector used on FLIR's Tau 2 camera accessories, it makes the FLIR Boson camera electrically pin-compatible to the same connection as the TAU 2 providing an easy way to integrate the Boson to an existing installation.

TAU 2 VPC or Camera Link
Using an existing TAU 2 VPC or Camera Link Accessory Module is possible. Plug the Boson Tau 2 replicator accessory directly into the rear of the Boson camera 80-pin connector. Once connected, plug the Tau 2 accessory into the 50-pin connector. When the boards are mated, use the included screws to secure the boards to the camera.
Note: Using longer screws could damage the camera.

Reverse Polarity Protected
With the intelligent polarity sensing protection, the RHP-BOS-TAU-RB-IF can be powered with a 5-26VDC power source
INFORMATION | |
What's In The Box |