Menu
Your Cart

FLIR Tau PCB Wearsaver with Solder Pads

FLIR Tau PCB Wearsaver with Solder Pads
FLIR Tau PCB Wearsaver with Solder Pads
FLIR Tau PCB Wearsaver with Solder Pads
FLIR Tau PCB Wearsaver with Solder Pads
FLIR Tau PCB Wearsaver with Solder Pads
  • SKU: 421-0047-00
$117.00

FLIR Tau PCB Wearsaver with Solder Pads

A low-profile adapter that attaches to the Tau's 50-pin Hirose connector, furnishing a solder pad interface. Schematic included.

The Tau2 Wearsaver was designed to be an internal engineering/manufacturing calibration accessory, rather than an OEM interface.
There is a Hirose mating connector on one side of the board, as shown in the picture below:

When the Wearsaver is attached to the Tau2 camera, there are no exposed connectors, just the solder pads for a 20-pin Samtec (and 14 pads for pogo pins).

The pad connections are limited to input power, RS-232, analog video, and LVDS.

The Wearsaver board does NOT provision for External Sync, Discretes, or CMOS signals.

The physical layout is shown in the picture below: 



Write a review

Note: HTML is not translated!
Bad Good
Captcha